Ardex Endura Tile Adhesives

*Slurry bonding coat is prepared by mixing 2 parts of portland cement to 1 part of ADMIX AD1. Brush on the base immediately before applying the adhesive. MixingAdd SILVER STAR to clean water. Mix thoroughly until a lump-free mortar is obtained. A 20 kg bag will require approx. 4.5 - 5 litres of water to obtain a slump-free consistency. The adhesive is immediately ready-for-use and has a pot life of 3 hours. No further water should be added. Where mixing by weight is not possible, volume mixing can be carried out at site in the ratio of 1 : 3 (water : powder)APPLICATION1. Spread not more than the area which can be tiled within the open time of the adhesive.2. Comb the adhesive to the required depth using a suitable square notch trowel.3. Press the tiles firmly into position with a slight twisting action, checking periodically that good contact is maintained with the back of each tile. Leave no voids behind tiles.4. Tiles should be fixed within 15 minutes of adhesive being applied, depending on the porosity of the surface and atmospheric conditions. Tiles can be adjusted up to 5 - 10 minutes after fixing. Touch the adhesive ribs periodically and if a skin has formed, remove the adhesive and apply a new layer.5. Leave adequate joints between individual wall and floor tiles unless self spacing tiles are used.6. Clean off surplus adhesive from the tile face and between joints.Note:Ÿ Do not use in damp conditions and temperature less than 5°C Ÿ Use suitable clamps along with adhesive at the time of installation of tiles at height of more than 6m. Ÿ Leave movement joints at every 3m vertical interval and fill with a flexible sealant as per BS 5385.SPACERSUse ARDEX ENDURA spacers for uniform joint width.

• Delivery Time: One day